Brocade Communications Systems Mobility 7131 Series Guía de instalación descargar pdf (Pagina 29)

Brocade Mobility 7131 Installation Guide - Dependent Mode 21

53-1001567-04

Chapter

Basic Mobility 7131 Configuration

For the basic setup described in this guide, the Java-based Web UI will be used to

configure the Mobility 7131. To access the Mobility 7131 through the GE1/POE

port, the GE1/POE port default setting is DHCP client. For this example, the Mobility

7131’s WAN interface will be used to connect to the access point. The default WAN

IP address is 10.1.1.1. For optimal viewing of the Mobility 7131 Web UI, the screen

resolution should be set to 1024 x 768 pixels or greater.

NOTE

For advanced configuration options beyond the scope of this guide, refer to the

Mobility 7131 Product Reference Guide. The guide is available on the Brocade Web

site, at http://www.brocade.com/support/.

1. Start a browser and enter the following IP address in the address field:

https://10.1.1.1

NOTE

For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher (available

from Sun’s Website), and be sure to disable Microsoft’s Java Virtual Machine if

installed.

NOTE

The computer being used should be configured to use the same IP address and

subnet mask as the Mobility 7131.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Sin comentarios

Brocade Communications Systems Mobility 7131 Series Guía de instalación Pagina 29