Power supply and fan assembly status LED behavior, description, and required actions
(Continued)
TABLE 6
LED Color Description Action Required
Steady green Power supply and fan assembly is operating
normally.
No action is required.
Flashing green (for
more than 5
seconds)
Power supply and fan assembly is faulty for one of
the following reasons:
• The assembly is switched off - flashing for ~ 5
seconds, then off
• The power cable is disconnected - flashing for ~
5 seconds, then off
• The power supply and fan assembly has failed
NOTE: When the Brocade 6510 is first powered on,
the power supply and fan assembly status LED will
show flashing until POST has completed.
Try one of the following:
• Check the power cable connection.
• Verify that the assembly is
powered on
• Replace the power supply and fan
assembly FRU.
Determining the need to replace a power supply and fan assembly
Use one of the following methods to determine the status of the power supplies:
• Check the power supply and fan assembly status LED next to the On/Off switch (see LED locations
on page 30)
• In Web Tools, click the Power Status icon.
• Enter the psShow command at the prompt to display power supply and fan assembly status as
shown below:
br6510:admin> psshow
Power Supply #1 is OK
V10529, TQ2H0000030 ,60-0300031-01,X2, ,SP640 ,2X,TQ2H0000
Power Supply #2 is OK
V10541, TQ2H0000189 ,60-0300031-01,X3, ,SP640-2P ,A ,TQ2H0000
br6510:admin>
Time Required
Replacing a power supply and fan assembly in the Brocade 6510 should require less than two minutes
to complete.
Items Required
The following items are required to replace a power supply and fan assembly:
• New power supply and fan assembly (must have the same airflow as the FRU being replaced)
• Phillips-head screwdriver #1
Determining the need to replace a power supply and fan assembly
Brocade 6510 Hardware Installation Guide 45
53-1002174-10
Comentarios a estos manuales