Brocade Communications Systems MLX Series Guía de instalación descargar pdf (Pagina 190)

176 Brocade MLX Series and NetIron XMR Hardware Installation Guide

53-1003267-02

Installing a NetIron XMR 32000 router

For information about how to disable and re-enable power to interface modules, refer to “Disabling

and re-enabling power to interface modules” on page 223.

Before installing a module in the NetIron XMR 32000 router, have the following items available:

• A large flat-blade screwdriver.

• An ESD wrist strap with a plug for connection to the ESD connector on the router chassis.

DANGER

For safety reasons, the ESD wrist strap should contain a 1 megohm series resistor.

CAUTION

If you are hot-swapping a module, allow a minimum of two seconds after a module (or power

supply or fan tray) has been removed before inserting a module in the same slot.

Follow these steps to install a module in the NetIron XMR 32000 router. The installation steps are

identical for management modules, interface modules, and switch fabric modules.

1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on

the router chassis.

2. Remove the module from the packaging.

3. Remove the two shipping panels by unscrewing the six captive screws holding each panel.

4. With the ejectors rotated away from the module faceplate, insert the module into the slot (refer

to Table 25) and slide the module along the card guide until the ejectors rotate towards the

module faceplate.

NOTE

When inserting the module into the router, make sure that the faceplate doesn’t overlap with

the faceplate of an adjacent interface module.

5. Rotate the ejectors flush with the module faceplate to seat the module in the backplane.

Modules have a snug fit for maximum EMI protection.

FIGURE 118 Installing a module in the NetIron XMR 32000 router

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 341 342

Sin comentarios

Brocade Communications Systems MLX Series Guía de instalación Pagina 190