Brocade Communications Systems Gateway Manual de servicio Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 104
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
FIGURE 5 Port mapping example
The following table describes the port mapping details for the above example.
Description of port mapping TABLE 6
Access Gateway Fabric
F_Port N_Port Edge switch F_Port
F_1, F_2 N_1 Switch_A F_A1
F_3, F_4 N_2 Switch_A F_A2
F_5, F_6 N_3 Switch_B F_B1
F_7, F_8 N_4 Switch_B F_B2
Default port mapping
When you first enable a switch for AG mode, the F_Ports are mapped to a set of predefined N_Ports
by default. The table below describes the default port mapping for all supported hardware platforms.
By default, Failover and Failback policies are enabled on all N_Ports.
If you want to change the default mapping, refer to Adding F_Ports to an N_Port on page 35. Note
that all F_Ports must be mapped to an N_Port before the F_Port can come online.
Default port mapping
30 Access Gateway Administrator's Guide
53-1003126-02
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 103 104

Comentarios a estos manuales

Sin comentarios