Brocade Communications Systems Gateway Manual de servicio Pagina 72

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 104
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 71
Failback policy configurations in Access Gateway
The following sequence describes how a failback event occurs:
When an N_Port comes back online, with the Failback policy enabled, the F_Ports that were
originally mapped to it are temporarily disabled.
The F_Port is rerouted to the primary mapped N_Port, and then re-enabled.
The host establishes a new connection with the fabric.
NOTE
The failback period is quite fast and rarely causes an I/O error at the application level.
Failback example
In Example 3, described below, the Access Gateway N_1 remains disabled because the
corresponding F_A1 port is offline. However, N_2 comes back online. See Failover example on page
66 for the original failover scenario.
Ports F_1 and F_2 are mapped to N_1 and continue routing to N_3. Ports F_3 and F_4, which were
originally mapped to N_2, are disabled and rerouted to N_2, and then enabled.
Failback policy configurations in Access Gateway
72 Access Gateway Administrator's Guide
53-1003126-02
Vista de pagina 71
1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 103 104

Comentarios a estos manuales

Sin comentarios