Brocade Communications Systems Gateway Manual de servicio descargar pdf (Pagina 58)

FIGURE 10 Port group 1 (PG1) setup

Adding an N_Port to a port group

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the ag --pgadd command with the appropriate options to add an N_Port to a specific port

group. In the following example, N_Port 14 is added to port group 3.

Note that if you add more than one N_Port, you must separate them with a semicolon.

switch:admin> ag --pgadd 3 14

N_Port[s] are added to the port group 3

Deleting an N_Port from a port group

Before deleting an N_Port, all F_Ports mapped to the N_Port should be remapped before the N_Port

is deleted from a port group.

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the ag --pgdel command with the appropriate options to delete an N_Port from a specific port

group. In the following example, N_Port 13 is removed from port group 3.

switch:admin> ag --pgdel 3 13

N_Port[s] are deleted from port group 3

3. Enter the ag --pgshow command to verify the N_Port was deleted from the specified port group.

Removing a port group

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the ag --pgremove command with the appropriate options to remove a port group. In the

following example, port group 3 is removed.

switch:admin> ag --pgremove 3

Adding an N_Port to a port group

58 Access Gateway Administrator's Guide

53-1003126-02

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 103 104

Sin comentarios

Brocade Communications Systems Gateway Manual de servicio Pagina 58